We specialise in the maintenance, repair and replacement of concrete to warehouse floors. We provide preventative maintenance programs through to full replacement of sections of the floor either while in production or out of hours on weekends or evenings. We also carry out concrete repairs to the warehouse floor surface through to complete re surface systems such as epoxy, urethane coatings.
We can provide preventative maintenance jointing systems that will prevent the spalling of the joint edges from the construction stage thus protecting the tenant / owner from expensive repair bills and costly shut downs. We can also carry out the repairs once spalling has occurre d with minimum down time using fast curing resins and grouts that can allow for full rebuild of a joint to a trafficable stage in an 8 hour shift.
Our dry cutting methods include the use of dust extraction equipment to prevent dust contamination of stock and equipment and also wet cutting and grinding for maximum dust control.
We have experience and systems in place for the repair and maintenance of:
- Saw cut joints
- Construction joints in conventional reinforced or un reinforced concrete
- Construction joints in post tensioned concrete
- Replacement of concrete where necessary with high strength fast cure grouts and concrete that can support traffic in one hour.

Photo showing a semi rigid joint repair that was carried out in a high use warehouse in 2006. The joint is still providing support for the solid wheel loads that are being applied.
The clear coating to the joint is to seal the surface of the concrete after grinding. We have normal and fast cure products for this application.

Photo showing a joint that has had both edges rebuilt then the centre of the joint treated with a semi rigid filler.
The rebuilding of the edges was due to the extent of the joint edge spalling which was approx 50mm wide. This form of joint repair can be achieved in an 8 hour shift using high strength fast cure grouts and coatings.
cold room & freezer floor repairs
Specialist contractors in the concrete floor and joint repair market in cold and freezer rooms.
JOINT SEALING-JOINT EDGE-REPAIRS-SPALLING REPAIRS-CONCRETE REPLACEMENT
JOINT RESEALING
We have the equipment and products that enable us to remove existing sealants, prepare bonding surfaces then prime and install new sealants with minimal disruption to warehouse operations. We can supply a range of sealants from highly flexible to seal the joints from water ingress to semi rigid fillers that can support the fork lift wheels and prevent joint edge spalling.
SPALLING REPAIRS
Spalling repairs from small to large can now be carried out without disruption to operations. we have battery powered equipment so that preparation can be carried out in isolated areas without the need for extension leads and we have products that will cure and take fork lift traffic within 10 minutes. For food prep areas we can supply and install non tainting repair products.


joint sealing
Specialised Contracting Solutions also specializes in the structural repairs and upgrades of commercial swimming pools.
We can repair structural defects, prepare and apply swimming pool coatings, reseal joints, carry out repairs to waterstops, install starter blocks and hand rails etc, retile walls / floors, and upgrade swimming pool concourse areas with slip resistant finishes.
SWIMMING POOL CONCOURSE UPGRADE
We have several different options for the upgrade of the swimming pool concourse including epoxy flake and spray on cement toppings.
We also replace concourse concrete to fall to drains and carry out grinding/scarifying to create falls in existing concrete.
PROTECTIVE COATING – SWIMMING POOL COATING INCLUDING SCHOOL EMBLEM
We use both epoxy and chlor rubber based coatings for the protection of the concrete structures and can supply stencils for the application of emblems etc in the pools.
This pool has had several wall tiles replaced, the base of the pool prepared ready for a new coating and the existing sealant removed from the joints ready for the new coating and sealant.
Cleaning of the wall tiles is underway prior to the new coating installation.


coatings and maintenance of swimming pools
Specialised Contracting Solutions also specializes in the structural repairs and upgrades of commercial swimming pools.
We can repair structural defects, prepare and apply swimming pool coatings, reseal joints, carry out repairs to waterstops, install starter blocks and hand rails etc, retile walls / floors, and upgrade swimming pool concourse areas with slip resistant finishes.
SWIMMING POOL CONCOURSE UPGRADE
We have several different options for the upgrade of the swimming pool concourse including epoxy flake and spray on cement toppings.
We also replace concourse concrete to fall to drains and carry out grinding/scarifying to create falls in existing concrete.
PROTECTIVE COATING – SWIMMING POOL COATING INCLUDING SCHOOL EMBLEM
We use both epoxy and chlor rubber based coatings for the protection of the concrete structures and can supply stencils for the application of emblems etc in the pools.
This pool has had several wall tiles replaced, the base of the pool prepared ready for a new coating and the existing sealant removed from the joints ready for the new coating and sealant.
Cleaning of the wall tiles is underway prior to the new coating installation.




epoxy flooring /coatings
Specialised Contracting Solutions specialise in the application of epoxies, both abrasion and chemical resistant coatings for the protection of concrete to floors including
Garage floors • Workshop floors • Industrial building floors


concrete repairs
Specialised Contracting Solutions provide a range of concrete repair solutions utilizing proprietary, pre-bagged products that ensure compatibility with the parent concrete and long term durability:
- Reinforced concrete repair applications utilizing cementitious based repair products – mortars, fairing coats and micro concretes
- Reinforced concrete repair applications utilizing epoxy based repair products capable of withstanding severe abrasion and chemical attack
- Ability to undertake all forms of concrete repair to reinforced concrete including structural component

